Digital Power Meter PoE Switches

Explore All Digital Power Meter PoE Switches

Unmanaged PoE++ Switch Gigabit 16 Ports 2 SFP, 2 RJ45 Uplinks, Metal Housing for IP Surveillance

Unmanaged PoE++ Switch Gigabit 16 Ports 2 SFP for IP cameras and APs. 60W on one port, 250m extend mode, VLAN isolation, plug and play.

SG1622P-DPM
Port Description

16 x 10/100/1000Base-T PoE ports (1 x 802.3bt PoE++ up to 60W, 15 x 802.3af/at PoE+ up to 25.4W), 2 x 10/100/1000Base-T uplink ports, 2 x 1000Base-X SFP uplink slots
  • Unmanaged gigabit PoE++ switch with 16 ports and 2 SFP slots for fiber uplinks.
  • One IEEE 802.3bt PoE++ port delivers up to 60W for high-power PTZ cameras and access points.
  • 15 IEEE 802.3af/at PoE+ ports deliver up to 25.4W each for standard IP cameras, VoIP phones, and APs.
  • DIP switch controls 250m long-distance mode (10M) and VLAN isolation mode for ports 1-16.
  • Digital LED PoE usage display shows remaining power headroom at a glance.
  • Metal housing, internal AC power supply, desktop or rack-mount installation.









Unmanaged PoE++ Switch Gigabit 16 Ports 2 SFP for Real-World Network Deployments

For IP camera installs, wireless access point rollouts, or small business LANs, this unmanaged PoE++ switch gives you 16 gigabit PoE ports, 2 extra copper uplink ports, and 2 SFP slots in one metal case. No CLI, no management platform, no training. Plug in the switch, connect the devices, and it automatically decides which powered devices need PoE before sending power. That protects non-PoE equipment from accidental damage.

One port supports IEEE 802.3bt PoE++ up to 60W, so you can use it for a PTZ camera or a high-performance AP. The other 15 PoE ports deliver up to 25.4W each, enough for typical IP cameras and VoIP phones. The unit is rated for a maximum 200W total power draw, so in many cases you can run a full camera array without adding a separate injector on every cable run. That alone simplifies wiring and lowers install cost.

A hardware switch on the unit gives you two practical modes for edge installations. In 10M extend mode, ports 1 to 16 drop to 10Mbps and can push signals up to 250m over existing twisted-pair cable, which is useful when a camera or sensor sits beyond the standard 100m limit. In VLAN mode, ports 1 to 16 are isolated from each other but all still talk to the uplink ports. That reduces broadcast noise and keeps one device from flooding the whole network. The digital LED also shows PoE utilization, so you can check remaining headroom at a glance.

This switch is built for shops, hotels, offices, and residential video surveillance setups where simplicity matters more than a feature-packed managed box. The metal housing helps with heat dissipation, the internal AC power supply makes installation cleaner, and the optional 6kV/4kV surge protection and AI watchdog add reliability for unattended sites.

  • Unmanaged gigabit PoE++ switch with 16 ports and 2 SFP slots
  • IEEE 802.3bt on one port for up to 60W output
  • 15 IEEE 802.3af/at PoE+ ports for up to 25.4W per port
  • DIP switch controls 250m long-distance mode and VLAN port isolation
  • Metal housing, desktop or rack-mount setup, wide temperature range

SG1622P-DPM Technical Specifications

  • Type: Unmanaged 16-port gigabit PoE++ switch with 2 SFP slots
  • Standards: IEEE802.3 10Base-T, IEEE802.3u 100Base-TX, IEEE802.3ab 1000Base-T, IEEE802.3z 1000Base-SX/LX, IEEE802.3af/at/bt PoE, IEEE802.1p tagged frames, IEEE802.3x flow control
  • Ports: 16 x 10/100/1000Base-T PoE ports, 2 x 10/100/1000Base-T uplink ports, 2 x 1000Base-X SFP slots
  • PoE Output: 1 x port up to 60W (IEEE802.3bt), 15 x ports up to 25.4W (IEEE802.3af/at)
  • PoE Pin Assignment: 1/2+, 3/6-
  • Switching Mode: Store-and-forward
  • Switching Capacity: 40Gbps
  • Forwarding Rate: 29.76Mpps
  • MAC Address Table: 8K
  • Packet Buffer: 4Mbit
  • Jumbo Frame: 10K
  • Other Features: Auto-negotiation, auto MDI/MDI-X, flow control
  • Transmission Distance: 10Base-T up to 250m in extend mode, 100Base-TX/1000Base-T up to 100m
  • SFP Distance: multimode 550m/2km; single-mode 2/20/40/60/80/100km
  • Power Input: AC 100-240V, 50Hz
  • Power Consumption: Standby ≤10W, full unit ≤200W
  • Enclosure: Metal
  • Installation: Desktop, rack-mount
  • Cooling: Natural cooling, fan
  • Dimensions: 311 x 182 x 44 mm
  • Weight: Net 1.4kg, gross 1.7kg
  • Operating Temperature: -20°C to 60°C
  • Storage Temperature: -20°C to 75°C
  • Relative Humidity: 5% to 95% non-condensing
  • Protection Options: 6KV common mode / 4KV differential mode surge, AI watchdog
  • Warranty: 3 years

Product size: Unmanaged PoE++ Switch Gigabit 16 Ports 2 SFP, 2 RJ45 Uplinks, Metal Housing for IP Surveillance

Application: Unmanaged PoE++ Switch Gigabit 16 Ports 2 SFP, 2 RJ45 Uplinks, Metal Housing for IP Surveillance


加载中…